Bar Lights
Batten Lights
Batten Fix Lights(DIY)
Bedside Table Lamps
Cabinet Lights
Ceiling Lights
Chandeliers
Close to Ceiling Light (CTC)
Copper Lights
Emergency Lighting
Fairy Lights
Floor Lamps
High Bay Lights (UFO)
Lamps
Mirror Lights
Oyster Lights
Pendants Lighting
Plaster Wall Lights
Smart Lights
Spot Lights
Table Lamps
Touch Table Lamps
Up/Down Wall Lights
Vanity Lights
Wall Lights
LED Strips
LED Strips Controller
Batten Lights
Bollard Lighting
Brick Lights
Bunker Lights
Coach Lighting
Deck Lights
Driveway Lights
Fairy Lights
Flood Lights
Garden Lighting
Inground Lights
Pathway Lighting
Pillar Mount
Pond Lights
Posts Lights/Top
Outdoor Ceiling Lights
Outdoor Sensor Lights
Outdoor Wall Lights
Solar Lights
Spike Lights
Step Lights
Up/Down Wall Lights
Clearance Sale
LoginCouldn't load pickup availability
The Slim is the flattest ceiling light Havit makes: a polycarbonate disc 26 mm deep whose whole face lights up, so it reads as part of the ceiling rather than as a fitting hanging off it. This is the smallest of the four sizes, and its data sheet measures the body at Ø210 mm — the listing name rounds that to 200 mm, so allow the full 210 mm when you are working to a tight ceiling detail.
It puts out 1,400–1,500 lm, which is the right amount for a hallway, a laundry, a walk-in robe, a small bathroom or a stair landing — rooms where you want the ceiling clear and the light even rather than dramatic. For a bedroom or a living room the 24 W and 30 W bodies in the same range are the better match; they are the same 26 mm depth, so going bigger costs width and nothing in ceiling presence.
A slide switch in the base selects 3000K, 4000K or 5500K and is set once at installation. Output is not a ladder: 4000K is the brightest at 1,500 lm, 5500K gives 1,450 lm and 3000K gives 1,400 lm. If you want the most light out of the fitting, choose the middle setting rather than the coolest one.
Havit rates this model at CRI >90 with SDCM <3 and UGR <25. CRI >90 matters in a bathroom or a robe, where you are judging skin tone and the colour of clothes; SDCM <3 means two of these installed side by side in a hallway will look like the same white, which is the fault people notice long before they notice a lumen difference.
It is IP54 and IK06, and Havit attaches one condition to that in writing: if it is installed on any surface other than a ceiling — a wall, for instance — the rating drops to IP20. So it is a ceiling fitting for a bathroom or laundry, and it is not a wall fitting for a wet area at all.
Surface mounted, so there is no cutout. The base plate is Ø164 mm with two fixing holes, and the body twists onto it. It runs on 240 V AC with no separate driver, and is Protection Class 2, so no earth is required at the fitting. The supplied male and female connector must not be removed. It is Triac dimmable, with Havit's HV9625 listed as the matched dimmer, and carries a 3 years replacement warranty. Lights For You stocks the whole Slim range, so the size can be chosen against the room rather than against a catalogue photo.
No. It is surface mounted. The Ø164 mm base plate screws to the ceiling through two fixing holes, the supply cable comes through the centre, and the Ø210 mm body twists onto the plate. Nothing recesses into the ceiling cavity.
On the ceiling, yes — it is IP54, which covers dust and splashing water. Havit states in the installation instructions that mounting it on any surface other than a ceiling downgrades the rating to IP20, so it should not be used on a bathroom wall. Your electrician will place it against the AS/NZS 3000 zones for the room.
4000K, at 1,500 lm. 5500K gives 1,450 lm and 3000K gives 1,400 lm, so the brightest setting is the middle one, not the coolest. The difference is small enough that you should choose on the look you want.
Yes, but not from below. The slide switch sits in the base of the fitting, so the body has to be twisted off the plate to reach it. Decide the setting before the electrician leaves, or expect to take it down again.
No. The body and diffuser are polycarbonate and Havit specifies it as Protection Class 2, so no earth connection is required at the fitting itself.
It is Triac dimmable and Havit lists the HV9625 as the matched control. A 16 W load is small, so if it is the only fitting on the circuit check the dimmer’s minimum load — an underloaded Triac dimmer is the usual cause of flicker at the bottom of the range.
Ø210 mm is the figure on the data sheet and on the installation drawing; 200 mm is the rounded name the range is sold under. Work to 210 mm if you are lining the fitting up with a tile joint, a bulkhead or another light.
| Range | Slim |
|---|---|
| Type | Surface mounted oyster |
| Material | Polycarbonate |
| Finish | White |
| Diffuser | Polycarbonate |
| Installation type | Ceiling — surface mounted (no cutout) |
| Lamp base | Built-in LED |
| Power | 16 W |
| Colour temperature | Tri colour — 3000K, 4000K, 5500K (switch-selected at installation) |
| Lumen output | 1,400 lm / 1,500 lm / 1,450 lm (3000K / 4000K / 5500K) |
| CRI | >90 |
| SDCM | <3 |
| UGR | <25 |
| Beam angle | 120° |
| IP rating | IP54 — downgrades to IP20 if mounted on any surface other than a ceiling |
| IK rating | IK06 |
| Input voltage | 240 V AC |
| Protection class | Class 2 (no earth required) |
| Dimmable | Yes — Triac (HV9625 is the matched dimmer) |
| Lamp expectancy | >30,000 hrs |
| Dimensions | Ø210 mm × 26 mm deep |
| Mounting base | Ø164 mm |
| Warranty | 3 Years Replacement* |
| Part number | Finish | Colour temperature | Lumens | Power | Input voltage | Diameter | Barcode |
|---|---|---|---|---|---|---|---|
| HV5876T-WHT | White | 3000K / 4000K / 5500K | 1400lm / 1500lm / 1450lm | 16 W | 240 V AC | Ø210 mm | 9350418034038 |
For all warranty claims please ensure you have your proof of purchase at hand, an invoice from your electrician from the installation and check the faulty product is within the applicable warranty period. Warranty is replacement only.
Lights For You is not responsible for damages caused by unprofessional installation, modified products or manipulated by the customer or by any other person not authorised by the manufacturer; as well as by improper use, manipulation and/or short circuits, apparent signs of improper treatment.
Notification of any damages or missing items must be received by Lights For You within seven (7) days of receipt of the product. Please email photos to ashfield@lightsforyou.com.au.
If the product is to be repaired or replaced, it must correspond to the one originally sent by Lights For You and the customer must include the delivery note and/or invoice.
You must lodge a return request via the below request form.
Credits will be issued in the form of store credit or gift voucher and will be equal to the price paid for the product minus the cost of shipping. Store credit vouchers are valid for six months from the date of issuance.
We reserve the right to refuse a return in cases where we cannot be reasonably satisfied that you purchased the product from us or where we are not responsible for the damage in accordance with our Faults & damages policy.
Customers who wish to cancel all or part of an order due to change of mind or incorrectly ordered may do subject to cancelling in within 12 hours, during business hours from time of purchase. Once products have been shipped, you cannot cancel them.
Please refer to the following link to learn more about our policies
Learn MoreThanks for subscribing!
This email has been registered!
| Product | SKU | Product type | Other details |
|---|