Silver Wall Mounted Bracket to suit Aluminium Profile

Silver Wall Mounted Bracket to suit Aluminium Profile

This is a wall-mounting bracket, to suit the HV9705-WB-SLV aluminium profile.

⚠ It is a fitting accessory on its own. There is no LED strip in it, no channel and no driver - it is one of the parts that holds a profile run where it needs to be.

What it does

A bracket holds the profile off the wall at a fixed distance, which is what lets a run wash light along a surface instead of pressing it flat against one. The gap is the whole point: it is what turns a line of light into a graze across the wall.

Because the bracket sets that distance, it also sets how the light reads. Consistent brackets along a run give an even wash; brackets at differing depths give a line that visibly wanders.

Ordering the right one

⚠ These parts are shaped to a particular profile and do not interchange. Confirm the profile part number - HV9705-WB-SLV - before ordering.

Count what the job needs from the length of the run rather than ordering a nominal few. Fixings are spaced along a run, so a longer profile needs proportionally more of them, and a channel fixed at too few points will show a visible sag or a wave in the line of light once it is switched on.

It is worth having one or two spare. These are the smallest components in a profile installation and the ones most easily mislaid on site, and a run left unfixed while a replacement is ordered rarely gets finished promptly.

Installing it

Fit these before the strip and the diffuser go in. Working on a channel that is already loaded means either working around the strip or taking it back out, and the adhesive backing on LED strip does not always survive a second attempt.

Check the run is straight and sitting flat as you go rather than at the end. A profile is rigid enough to hide a small misalignment while it is loose, and rigid enough to make it permanent once it is fixed.

Frequently asked questions