Right Side Entry Solderless Connection Cap

Right Side Entry Solderless Connection Cap

This is a solderless connection cap to suit flexible LED strip.

⚠ It is a component on its own. There is no LED strip in it and no driver - it is one of the parts that holds, joins or terminates a strip run you already have.

What it does

This is the end cap that both terminates a run of flexible strip and brings the cable into it, without soldering. It does two jobs at once: it seals the cut end, and it makes the electrical connection.

The cut end of flexible strip is the vulnerable point of any run. It exposes the circuit inside the silicone, and on an outdoor or damp installation that is where water gets in - not through the jacket, which is doing its job, but through the end that was left as the saw finished it.

This is the right side entry version, so the cable leaves the run at the right side. ⚠ Choose the entry direction to match where the cable actually has to go: the wrong one forces a tight bend right at the join, which is the worst possible place to put strain.

Why solderless matters here

Soldering a flexible strip means opening the silicone, working on the circuit inside it, and then re-sealing it well enough to hold back water. That is a fussy job in a workshop and a difficult one on a ladder.

A solderless cap replaces all of it with a fitting that clamps and seals in one action, which makes the result far more repeatable - and repeatability is what matters on a run with several terminations.

Using it

Cut the strip square and at a marked cutting point. A skewed cut will not seat properly in the cap, and a cut off the marks leaves no contacts to clamp onto.

⚠ Confirm the cap suits flexible LED strip before ordering. These are sized to one strip section and will not seal on another.

Frequently asked questions