-
Downlights -
Globes -
Fans
-
Heaters
-
Indoor Lighting
Interior
-
Indoor Lighting
-
Bar Lights
-
Batten Lights
-
Batten Fix Lights(DIY)
-
Bedside Table Lamps
-
Cabinet Lights
-
Ceiling Lights
-
Chandeliers
-
Close to Ceiling Light (CTC)
-
Copper Lights
-
Emergency Lighting
-
Fairy Lights
-
Floor Lamps
-
High Bay Lights (UFO)
-
Lamps
-
Mirror Lights
-
Oyster Lights
-
Pendants Lighting
-
Plaster Wall Lights
-
Smart Lights
-
Spot Lights
-
Table Lamps
-
Touch Table Lamps
-
Up/Down Wall Lights
-
Vanity Lights
-
Wall Lights
-
-
Indoor Lighting
-
Lamps
-
LED Lights -
LED Strips
-
Pendant Lighting
-
Outdoor Lighting
Exterior
-
Outdoor Lighting
-
Batten Lights
-
Bollard Lighting
-
Brick Lights
-
Bunker Lights
-
Coach Lighting
-
Deck Lights
-
Driveway Lights
-
Fairy Lights
-
Flood Lights
-
Garden Lighting
-
Inground Lights
-
Pathway Lighting
-
Pillar Mount
-
Pond Lights
-
Posts Lights/Top
-
Outdoor Ceiling Lights
-
Outdoor Sensor Lights
-
Outdoor Wall Lights
-
Solar Lights
-
Spike Lights
-
Step Lights
-
Up/Down Wall Lights
-
-
Outdoor Lighting
-
Clearance Sale -
Login -
Create an Account
Loading...
+ Add to wishlist
- Remove from wishlist
A suggestion, not a specification. A calculator can get it wrong — have a licensed electrician confirm the driver, the total load and the wiring before you order.
Find the right driver for this fitting
Product Description
xThe Raker G23 is a 62 mm two-way inground light in black — 24 V, 3 W giving 14 lm at 3000 K, CRI above 95, IP65.
⚠ Two things to settle before you specify it.
- No load rating is recorded. Nothing in any source says whether the Raker can be walked on or driven over — which on a light set flush into the ground is the first question. Assume it is a garden-bed and edge fitting, not a driveway one, and ask us before putting it anywhere a car or a wheelbarrow goes. We are asking Telbix.
- It is IP65, not IP67. IP65 is rated against water jets; IP67 adds temporary immersion. An inground fitting sits exactly where water pools after rain, so this matters more here than anywhere else. Set it where the ground drains — not in a hollow, not at the bottom of a slope.
Two-way — and what that means for the output
The Raker throws light through two opposed slots rather than one, which is why it gives 14 lm where the one-way version gives 8. That near-doubling is the two sizes confirming each other: the aperture count sets the output, and the figures behave exactly as they should.
14 lumens is very small, and that is deliberate. The Raker is a marker and a grazing light, not an illuminator. Set into a path edge, a step, or against a wall, the two-way version washes light in both directions along the surface — which is how you light a path without floodlighting a garden. Anyone expecting an uplight for a tree wants a spike, not an inground marker: ask us about the Rilto.
CRI above 95 — and nothing said so
Equal highest in this catalogue, with the Rilto spike and the Malabo bollard. Grazing a brick wall, a stone step or a timber deck at close range is exactly where colour rendering shows: at CRI 80 the material goes flat and grey; at 95 the texture and the colour of the surface come back. On a fitting whose whole job is to graze a surface, that is the specification that matters.
24 volts — a transformer is required and is not supplied. The transformer must sit somewhere dry, be sized for the whole run and be wired by an electrician. We stock a 24 V 60 W and a 200 W outdoor unit; at 3 W each the 60 W drives a long run of Rakers. Tell us your layout and we will size it.
Class III low voltage also means the cable running through your beds is low voltage — far safer around spades and roots than mains, and much easier to extend later.
62 mm across, 56 mm cutout, 1 metre of cable
62 mm wide and 85 mm deep, into a 56 mm cutout, at 0.22 kg.
The cutout is recorded, which is worth noting — several recessed fittings in this catalogue do not record theirs. The 1,000 mm cable is what decides how far the joint can be, and on an inground fitting that joint has to be in a dry, accessible housing. Plan it before the paving or the mulch goes down.
One of three distributions
Raker comes as one-way, two-way and four-way. The one-way throws in a single direction — against a wall or a riser. This two-way washes along a path or a step from a single point. The four-way throws in all directions, for an open position where the fitting is the centre of the effect.
It is not dimmable, and the LED is integrated and included — nothing to buy and nothing to replace. A licensed electrician wires the transformer.
Where it works
- Path edges and step treads — washing light along the surface.
- Against walls, decks and stone, where CRI 95 shows the texture.
- Garden beds and mulch, in runs on one transformer.
- ⚠ Ground that drains — IP65 is jet-rated, not immersion-rated.
- ⚠ No load rating recorded. Ask us before a driveway or a trafficked path.
Specifying it
62 mm across by 85 mm deep, cutout 56 mm, cable 1,000 mm, 0.22 kg, in aluminium and glass, black. Integrated 3 W LED giving 14 lm at 3000 K through two opposed apertures, included, CRI >95, not dimmable. 24 V — a transformer is REQUIRED and is not supplied; we stock 60 W and 200 W. Class III low voltage, IP65 — jet-rated, NOT immersion-rated; set it where the ground drains. Load rating not recorded — ask us. Warranty is three years, as a replacement warranty.
Supplied and supported by Lights For You.
Questions
Can I walk on it or drive over it?
No source records a load rating, which on a light set flush into the ground is the first question. Assume it is a garden-bed and edge fitting rather than a driveway one, and ask us before putting it anywhere a car or a wheelbarrow goes. We are asking Telbix.
Is IP65 enough for an inground light?
It is rated against water jets but not against immersion — IP67 adds that. An inground fitting sits exactly where water pools after rain, so set it where the ground drains: not in a hollow, not at the bottom of a slope.
Why only 14 lumens?
Because it is a marker and a grazing light, not an illuminator. Set into a path edge, a step or against a wall, the two-way version washes light in both directions along the surface — which is how you light a path without floodlighting a garden. If you want to uplight a tree you want a spike; ask us about the Rilto.
What is the difference between one-way, two-way and four-way?
One-way throws in a single direction, against a wall or a riser. Two-way washes along a path or step from one point. Four-way throws in all directions, for an open position where the fitting is the centre of the effect. The output follows the apertures: 8 lm one-way, 14 lm two-way.
Why does CRI matter on a light this small?
Because its whole job is to graze a surface at close range. At CRI 80 brick, stone and timber go flat and grey; at 95 — equal highest in this catalogue — the texture and colour come back.
Do I need a transformer?
Yes, and none is supplied. It must sit somewhere dry, be sized for the run and be wired by an electrician. We stock a 24 V 60 W and a 200 W outdoor unit; at 3 W each the 60 W drives a long run. Tell us your layout.
What size hole does it need?
A 56 mm cutout, for a 62 mm fitting 85 mm deep. The cable is 1 metre, and the joint must sit in a dry accessible housing — plan that before the paving or mulch goes down.
Product Specifications
xSpecifications
| Brand | Telbix Lighting |
|---|---|
| Model / SKU | RAKER G23-BK324 (Black) — TWO-WAY |
| Type | Inground marker — 24V low voltage, two opposed apertures |
| Input Voltage | 24V — a TRANSFORMER IS REQUIRED and is NOT supplied |
| Transformers we stock | 24V 60W · 24V 200W outdoor — ask us to size the run |
| Wattage | 3W integrated LED — included |
| Lumen Output | 14lm — a marker and grazing light. The one-way gives 8lm |
| CRI | > 95 — EQUAL HIGHEST in this catalogue |
| Colour Temperature | 3000K warm white |
| Dimming | NO |
| IP Rating | IP65 — JET-rated, NOT immersion. Set it where the ground DRAINS |
| ⚠ Load rating | NOT RECORDED — ask us before a driveway or trafficked path |
| Electrical Protection | CLASS III — LOW VOLTAGE, under 54V |
| Width | 62mm |
| Depth | 85mm |
| Cutout | 56mm |
| Cable Length | 1000mm — the joint needs a dry, accessible housing |
| Weight | 0.22kg |
| Material | Aluminium and glass |
| Warranty | 3 Years — replacement warranty |
Variant specifications
| Order code | Apertures | Output | Throws light | Best for |
|---|---|---|---|---|
| RAKER G13-BK324 | One-way | 8lm | In one direction | Against a wall or riser |
| RAKER G23-BK324 | Two-way | 14lm | Both ways along a surface | Path edges and step treads |
| RAKER four-way | Four-way | Ask us | All directions | Open positions |
Data Sheet & Manual
xWarranties, Return & Refund Policy
xWarranties
For all warranty claims please ensure you have your proof of purchase at hand, an invoice from your electrician from the installation and check the faulty product is within the applicable warranty period. Warranty is replacement only.
Lights For You is not responsible for damages caused by unprofessional installation, modified products or manipulated by the customer or by any other person not authorised by the manufacturer; as well as by improper use, manipulation and/or short circuits, apparent signs of improper treatment.
Faulty items: lodge warranty directly with the brand (manufacturer). Keep proof of purchase.
Damaged or Missing Items
Notification of any damages or missing items must be received by Lights For You within seven (7) days of receipt of the product. Please email photos to ashfield@lightsforyou.com.au.
If the product is to be repaired or replaced, it must correspond to the one originally sent by Lights For You and the customer must include the delivery note and/or invoice.
Returns
Change of Mind Returns
- Customers who wish to return a product due to a change of mind or cancelled order may do so within thirty (30) days of receipt.
- The customer is responsible for the shipping costs for a change of mind return, irrespective of any free, discounted or any other type of shipping promotion that may have been applicable at the time of your order. This includes any costs you incur for us shipping the product to you in the first place and the cost of shipping the product back to us.
Lodge a Return
You must lodge a return request via the below request form.
Excluded from Change of Mind
- Clearance items
- Discontinued items
- Globes
- Custom items
- Made to Order (incl. custom cut profiles & LED strips)
- Lamp shades
- T4 fluorescent tubes
- Gift cards
Credits will be issued in the form of store credit or gift voucher and will be equal to the price paid for the product minus the cost of shipping. Store credit vouchers are valid for six months from the date of issuance.
Our Rights
We reserve the right to refuse a return in cases where we cannot be reasonably satisfied that you purchased the product from us or where we are not responsible for the damage in accordance with our Faults & damages policy.
Cancellations
Customers who wish to cancel all or part of an order due to change of mind or incorrectly ordered may do subject to cancelling in within 12 hours, during business hours from time of purchase. Once products have been shipped, you cannot cancel them.
Your Options
- Restocking fee: 20% will apply unless otherwise stated, or unless another order of equal or greater value is placed in lieu of this re-stocking fee.
-
Credit: will be issued in the form of store credit and will be equal to the price paid.
Please refer to the following link to learn more about our policies
Learn More
- Choosing a selection results in a full page refresh.