Bar Lights
Batten Lights
Batten Fix Lights(DIY)
Bedside Table Lamps
Cabinet Lights
Ceiling Lights
Chandeliers
Close to Ceiling Light (CTC)
Copper Lights
Emergency Lighting
Fairy Lights
Floor Lamps
High Bay Lights (UFO)
Lamps
Mirror Lights
Oyster Lights
Pendants Lighting
Plaster Wall Lights
Smart Lights
Spot Lights
Table Lamps
Touch Table Lamps
Up/Down Wall Lights
Vanity Lights
Wall Lights
LED Strips
LED Strips Controller
Batten Lights
Bollard Lighting
Brick Lights
Bunker Lights
Coach Lighting
Deck Lights
Driveway Lights
Fairy Lights
Flood Lights
Garden Lighting
Inground Lights
Pathway Lighting
Pillar Mount
Pond Lights
Posts Lights/Top
Outdoor Ceiling Lights
Outdoor Sensor Lights
Outdoor Wall Lights
Solar Lights
Spike Lights
Step Lights
Up/Down Wall Lights
Clearance Sale
LoginCouldn't load pickup availability
The Opex is a 1200 mm walnut timber linear pendant — a single suspended bar of light for a dining table, an island bench or a boardroom, where the fitting is meant to be seen as much as the light it throws. Part number HV6013T, 20 W built-in LED, hung on an adjustable cable from a small black canopy.
The suspension cable is 3000 mm and adjustable, which sounds forgiving and is only half true: Havit's installation sheet directs the electrician to "adjust cable length and cut off any excess" at step 4. The drop is therefore set once, with scissors, before the canopy goes up — so decide the height over the table first and hang it from the ceiling position you actually want, not from a temporary one. The mounting bracket is fixed to the ceiling first and the canopy pushes up over it and is locked with side screws, so the fixings are hidden once it is up.
A slide switch inside the canopy selects 3000K, 4000K or 5500K, and the fitting arrives preset to 3000K. Havit's ordering row measures 1600 lm at 3000K, 1800 lm at 4000K and 1700 lm at 5500K. The brightest setting is the middle one — not the coolest — so choosing 5500K over 4000K costs about 6% of the light rather than gaining any. Over a dining table that difference is invisible; the reason to move the switch is how the timber and the food look, and 3000K is the setting that suits walnut.
The beam is 120° behind a polycarbonate diffuser, so this is a broad, soft line of light rather than a row of pools. Hung about 750 mm above a table it lights the full width of a standard 900 mm top with no scallops on the surface, which is the point of a linear pendant over a set of separate spots. Glare is rated UGR <25 and colour rendering CRI >80, with colour consistency at SDCM <6.
It runs on 240 V AC and is Protection Class 1, so an earth is required at the fitting; Havit's step 5 is explicit that the earth is connected first, then active, then neutral. It is Triac dimmable from an ordinary wall dimmer and Havit lists the HV9625 300 W LED Dial Dimmer as the matching accessory. Multiple fittings are wired in parallel. Installation is a licensed electrician's work under AS/NZS 3000.
The rating is IP20 with an IK05 body: no water rating at all, so this belongs over a table, not in a bathroom, not under an eave and not in a carport. The body is walnut timber with aluminium, and Havit states plainly that "variations in colour, grain, and natural markings are inherent to walnut timber and are not considered defects" — knots, mineral streaks and tone differences are the material, not a fault, and two pendants ordered together will not be identical. Warranty is 3 years replacement. Lights For You publishes here only what this model's own dated data sheet and its installation sheet state for part number HV6013T.
The fitting is 1200 mm long. The suspension cable is 3000 mm and adjustable, but Havit’s installation sheet has the electrician cut off the excess, so the drop is set permanently at installation — decide the height before it goes up.
4000K, at 1800 lm. 3000K gives 1600 lm and 5500K gives 1700 lm, so the coolest setting is not the brightest and 3000K is the dimmest of the three.
By a slide switch inside the canopy, set before the fitting is closed up. It arrives preset to 3000K. It is not switched from the wall and not changed from an app.
Yes — it is Triac dimmable from a standard wall dimmer. Havit lists the HV9625 300 W LED Dial Dimmer as the matching accessory. Dimming performance always depends on the dimmer, so match it to a Triac dimmable LED load.
Yes. It is Protection Class 1 and the installation sheet directs the electrician to connect the earth first. It must be installed by a licensed electrician to AS/NZS 3000.
No. It is rated IP20, which carries no water rating, and the body is timber. It is an indoor fitting for a dining room, kitchen, office or reception space.
No, and Havit says so in writing: variations in colour, grain, texture and tone are inherent to walnut and are not considered defects. Knots and mineral streaks are part of the material.
| Range | Opex |
|---|---|
| Type | Linear pendant — ceiling suspended |
| Part number | HV6013T |
| Length | 1200 mm |
| Suspension | Cable, 3000 mm adjustable (cut to length at installation) |
| Material | Walnut timber + aluminium |
| Colour | Walnut + black |
| Diffuser | Polycarbonate |
| Lamp base | Built-in LED |
| Power | 20 W |
| Colour temperature | Tri colour — 3000K, 4000K, 5500K (slide switch in the canopy, preset 3000K) |
| Lumen output | 1600 lm / 1800 lm / 1700 lm (3000K / 4000K / 5500K) — brightest at 4000K |
| Beam angle | 120° |
| CRI | >80 |
| SDCM | <6 |
| UGR | <25 |
| IP rating | IP20 — indoor only |
| IK rating | IK05 |
| Input voltage | 240 V AC |
| Protection class | Class 1 — earth required |
| Wiring | Parallel |
| Dimmable | Yes — Triac (HV9625 300 W LED dial dimmer to suit) |
| Warranty | 3 Years Replacement* |
| Part number | Length | Colour temperature | Lumens | Power | Beam angle | Supply | Dimming | Barcode |
|---|---|---|---|---|---|---|---|---|
| HV6013T | 1200 mm | 3000K / 4000K / 5500K | 1600lm / 1800lm / 1700lm | 20 W | 120° | 240 V AC | Triac | 9350418034885 |
For all warranty claims please ensure you have your proof of purchase at hand, an invoice from your electrician from the installation and check the faulty product is within the applicable warranty period. Warranty is replacement only.
Lights For You is not responsible for damages caused by unprofessional installation, modified products or manipulated by the customer or by any other person not authorised by the manufacturer; as well as by improper use, manipulation and/or short circuits, apparent signs of improper treatment.
Notification of any damages or missing items must be received by Lights For You within seven (7) days of receipt of the product. Please email photos to ashfield@lightsforyou.com.au.
If the product is to be repaired or replaced, it must correspond to the one originally sent by Lights For You and the customer must include the delivery note and/or invoice.
You must lodge a return request via the below request form.
Credits will be issued in the form of store credit or gift voucher and will be equal to the price paid for the product minus the cost of shipping. Store credit vouchers are valid for six months from the date of issuance.
We reserve the right to refuse a return in cases where we cannot be reasonably satisfied that you purchased the product from us or where we are not responsible for the damage in accordance with our Faults & damages policy.
Customers who wish to cancel all or part of an order due to change of mind or incorrectly ordered may do subject to cancelling in within 12 hours, during business hours from time of purchase. Once products have been shipped, you cannot cancel them.
Please refer to the following link to learn more about our policies
Learn MoreThanks for subscribing!
This email has been registered!
| Product | SKU | Product type | Other details |
|---|