Luz Outdoor Up/Down LED Wall Light 2Lt in Black Havit Lighting - HV10291T

The Luz is Havit’s up-and-down wall pillar light in poly powder coated black aluminium, and the HV10291T is the two-lamp size — one GU10 firing up the wall, one firing down it. On a pier, a gate post or either side of a front door that symmetry is the whole effect: two soft cones that read as a lit surface rather than a bright fitting.

The globes are included, and they do the work

Havit supplies two 9-in-1 tri-colour GU10 globes with the fitting — you are not buying lamps separately. Each globe is switchable for both colour and output: 3000K, 4000K or 5500K, and 3 W, 5 W or 7 W. The figures below are per lamp, not the fitting’s total, which is double: 240–560 lm at 3000K, 255–595 lm at 4000K and 270–630 lm at 5500K, the low end being the 3 W setting and the high end the 7 W. Output rises as the light gets cooler, so 5500K at 7 W is the brightest this fitting goes.

You set the colour once, from inside

The switches sit on the side of the globe, not on the outside of the fitting, and Havit ships it preset to 3000K at 7 W. Changing it means twisting off a cover and removing the globe, so it is a decision made on the ladder at install rather than from the ground later. The cover twists back on against its seal — the lampholder is a standard GU10, so the globes are replaceable, up to 35 W per lampholder.

Sealing it properly is a warranty condition, not advice

Havit’s instructions are unusually direct about this: the backing plate must be installed and then every hole sealed, including the cable entry and the screw holes, and failure to do so voids the warranty. The o-rings and seals must all be in place for the same reason, and silicone goes around the base plate where it meets the wall. It is IP65 and IK10 rated with a clear glass diffuser, but that rating assumes the install was sealed. It is a 240 V mains fitting — no driver or transformer — and Class 1, so an earth is required.

Where it can and cannot go

This is the aluminium Luz, and Havit’s current instructions state that aluminium and 304SS fittings must not be installed within 5 km of any salt water environment. For a coastal address the solid brass Luz is the version to specify. Overall height is 300 mm and the body is 77 mm wide with a Ø60 mm aperture at each end; the backing plate takes four Ø4 mm fixings around a Ø13 mm cable entry. Havit’s drawing does not label its wall-projection figure, so we do not publish one — the dimensioned drawing is in the data sheet on this page.

It is Triac dimmable, and Havit names the HV9625 300 W dial dimmer as the compatible accessory. Lights For You keeps the Luz range on the shelf in all three finishes, and we are happy to talk through which size suits your pier before you order.