Bar Lights
Batten Lights
Batten Fix Lights(DIY)
Bedside Table Lamps
Cabinet Lights
Ceiling Lights
Chandeliers
Close to Ceiling Light (CTC)
Copper Lights
Emergency Lighting
Fairy Lights
Floor Lamps
High Bay Lights (UFO)
Lamps
Mirror Lights
Oyster Lights
Pendants Lighting
Plaster Wall Lights
Smart Lights
Spot Lights
Table Lamps
Touch Table Lamps
Up/Down Wall Lights
Vanity Lights
Wall Lights
LED Strips
LED Strips Controller
Batten Lights
Bollard Lighting
Brick Lights
Bunker Lights
Coach Lighting
Deck Lights
Driveway Lights
Fairy Lights
Flood Lights
Garden Lighting
Inground Lights
Pathway Lighting
Pillar Mount
Pond Lights
Posts Lights/Top
Outdoor Ceiling Lights
Outdoor Sensor Lights
Outdoor Wall Lights
Solar Lights
Spike Lights
Step Lights
Up/Down Wall Lights
Clearance Sale
LoginCouldn't load pickup availability
The Lorsa EXWB2 is a 160 mm up-down exterior LED wall light in black or white — two lamps, 18 W total, 1,400 lm, with switchable 2700 K / 3000 K / 4000 K, CRI above 90, IP65.
Two lamps throwing light up the wall and down it — the classic entry treatment, and the reason to choose this over the single. A pair of beams grazing render or brick describes the wall surface, where a single downward beam only lights the ground. From a body just 160 mm high and 78 mm wide, that is a lot of effect for very little fitting.
18 W at 78 lm/W. That is almost double the single and enough to light a wide entry on its own. Most up-down fittings this size manage a few hundred lumens and mark the wall rather than lighting it.
Most tri-colour exterior fittings run 3000 / 4000 / 5000 K. The Lorsa runs 2700 / 3000 / 4000 K — shifted warmer throughout. 2700 K is close to an old filament lamp and reads domestic and welcoming on a house facade. On an up-down fitting, where both beams land on the wall you chose the colour of, that warmth is very visible.
CRI above 90, across two beams. Most exterior LEDs sit at 80. Above 90 means brick, render and timber keep their real colour — and with light grazing the wall both upward and downward, this fitting shows more wall than most, so it shows more of the difference too.
Dust-tight and rated against water jets — unsheltered walls and hose-down are both fine. The body is polycarbonate throughout in a sand finish: nothing in it can corrode, which in a coastal position outlasts an aluminium fitting that will pit and chalk. Only 0.35 kg, projecting 99 mm.
Class II — double insulated, no earth required, which simplifies the exterior install. Not dimmable; the switch changes colour, not level.
160 mm high by 78 mm wide, projection 99 mm, 0.35 kg, in polycarbonate, sand finish. Two integrated LEDs, 18 W total, giving 1,400 lm, included, with switchable 2700 K / 3000 K / 4000 K, CRI >90, not dimmable. 240 V, Class II — double insulated, no earth required, IP65 — dust-tight, rated against water jets. Warranty is three years, as a replacement warranty.
Supplied and supported by Lights For You.
Yes — two lamps throwing light up the wall and down it from a single fixing. A pair of beams grazing render or brick describes the wall surface, where a single downward beam only lights the ground.
Almost double — 1,400 lm against 750, from 18 W against 9 W. That is enough to light a wide entry on its own; most up-down fittings this size manage a few hundred lumens.
Close to an old filament lamp. Most tri-colour exterior fittings run 3000 / 4000 / 5000 K; the Lorsa shifts the whole range warmer, and on an up-down fitting where both beams land on the wall, that warmth is very visible.
Yes — IP65 is dust-tight and rated against water jets, so it takes driven rain and can be hosed down.
Better than most — polycarbonate throughout, so nothing in it can corrode. In a coastal position it outlasts an aluminium fitting that will pit and chalk.
Yes — same width, same colours, same CRI and nearly the same efficiency, so a facade using both stays consistent.
No — Class II, double insulated, which simplifies the exterior install.
| Brand | Telbix Lighting |
|---|---|
| Model / SKUs | LORSA EXWB2-BK (Black) · EXWB2-WH (White) |
| Type | Exterior wall light — UP AND DOWN, two lamps |
| Finishes | Black · White — sand |
| Input Voltage | 240V |
| Lamp Holders | 2 |
| Wattage | 18W total — integrated LEDs, included |
| Lumen Output | 1400lm — lights a wide entry alone |
| Efficacy | 78 lm/W |
| Colour Temperature | SWITCHABLE 2700K / 3000K / 4000K — warmer range than most |
| CRI | > 90 |
| Dimming | NO — the switch changes colour, not level |
| IP Rating | IP65 — dust-tight, rated against water jets |
| Electrical Protection | CLASS II — double insulated, no earth required |
| Height | 160mm |
| Width | 78mm |
| Projection | 99mm |
| Weight | 0.35kg |
| Material | Polycarbonate — NO metal to corrode |
| Warranty | 3 Years — replacement warranty |
| Order code | Colour | Height | Lamps | Output |
|---|---|---|---|---|
| LORSA EXWB2-BK | Black | 160mm | 2 — up and down | 1400lm |
| LORSA EXWB2-WH | White | 160mm | 2 — up and down | 1400lm |
For all warranty claims please ensure you have your proof of purchase at hand, an invoice from your electrician from the installation and check the faulty product is within the applicable warranty period. Warranty is replacement only.
Lights For You is not responsible for damages caused by unprofessional installation, modified products or manipulated by the customer or by any other person not authorised by the manufacturer; as well as by improper use, manipulation and/or short circuits, apparent signs of improper treatment.
Notification of any damages or missing items must be received by Lights For You within seven (7) days of receipt of the product. Please email photos to ashfield@lightsforyou.com.au.
If the product is to be repaired or replaced, it must correspond to the one originally sent by Lights For You and the customer must include the delivery note and/or invoice.
You must lodge a return request via the below request form.
Credits will be issued in the form of store credit or gift voucher and will be equal to the price paid for the product minus the cost of shipping. Store credit vouchers are valid for six months from the date of issuance.
We reserve the right to refuse a return in cases where we cannot be reasonably satisfied that you purchased the product from us or where we are not responsible for the damage in accordance with our Faults & damages policy.
Customers who wish to cancel all or part of an order due to change of mind or incorrectly ordered may do subject to cancelling in within 12 hours, during business hours from time of purchase. Once products have been shipped, you cannot cancel them.
Please refer to the following link to learn more about our policies
Learn MoreThanks for subscribing!
This email has been registered!
| Product | SKU | Product type | Other details |
|---|