Luxe Up & Down LED Wall Light TRI

The Luxe is Havit’s compact up-and-down wall light in poly powder coated aluminium, sold here in black or white and wired straight to 240 V mains. A built-in LED throws a 120° wash up the wall and down it, so the wall does the lighting and the fitting itself stays quiet. It is the shape that ends up beside a front door, along a passage wall or up a garage pier.

One 9 W rating, and one lumen figure for the whole fitting

Havit rates the Luxe at 1 × 9 W and publishes its output as 400 lm at 3000K, 425 lm at 4000K and 450 lm at 5500K. Read those as the fitting’s total output — not a figure to double. Where a Havit up-and-down light carries two separate lamps, its ordering table says so and prints the lumens twice over; this one is rated for a single lamp and its figures are printed once. We publish them exactly as the ordering table gives them.

5500K is the brightest setting

Output rises with colour temperature on this fitting: 5500K is the brightest at 450 lm, 4000K sits at 425 lm and 3000K is the dimmest at 400 lm. Fifty lumens separate the ends, so it is no reason to pick a colour you do not want — but it is worth saying, because it is not a rule that carries between fittings. The direction is not the same on every Havit fitting, so it is not a rule to carry from one product to the next.

You set the colour once, from inside the base

It is tri-colour — 3000K, 4000K or 5500K — on a slide switch inside the base of the fitting, shipped preset to 3000K. Changing it means loosening the allen screws on the side and lifting the body off its base plate, so it is a decision made on the ladder rather than at the switchboard. The beam is a fixed 120°, not adjustable, and the fitting is not dimmable.

Mains only, and it needs an earth

There is one supply here: 240 V AC. It takes no driver and no transformer, and none is supplied. It is Class 1, so an earth is required — Havit’s instructions are to connect the earth first, then live and neutral. Where several sit on one run, wire them in parallel.

Sealing it is a warranty condition

Havit is specific about this: seal all holes, including the cable entry and around the screws, tighten the allen screws so water cannot penetrate, and apply silicone around the edge of the fitting. All o-rings and seals must be correctly in place to maintain the warranty, and modifying the fitting voids it. It is IP54 behind a glass diffuser with an IK09 impact rating — ratings that assume the install was sealed properly.

Where it can go, and what the drawing leaves out

The Luxe is aluminium, and Havit states that aluminium and 304SS fittings must not be installed within 5 km of any salt water environment — for a coastal address, ask us for a marine-grade alternative instead. It mounts on a base plate taking two Ø5 mm fixings around a Ø13 mm cable entry. Havit’s drawing prints the body’s overall figures without labelling which is height, which is width and which is depth, so we publish no overall dimensions and no wall projection; the dimensioned drawing on this page is the reliable reference. Lights For You keeps the Luxe in both finishes and will match it against the rest of your exterior before you order.