Matt Black Double Adjustable Wall Light

Two heads on one backing plate, each moving independently, in textured black over aluminium. The double adjustable Tivah is the fitting people buy when one light is not enough and two separate fittings would look like an afterthought — a tall entry wall, a pillar flanking a driveway, a facade where you want a defined up-and-down pattern rather than a single downward scallop.

Both heads move, separately

Each head has 90° of tilt and 270° of swivel, and they are set independently. That is what makes the fitting versatile rather than merely doubled: one head up the wall and one down gives the classic bidirectional column of light, both down gives twice the ground coverage, and both angled outward washes a wider span than any single head can. It is worth deciding the arrangement before the electrician leaves, because reaching a first-floor fitting later is a ladder job.

Every figure here is per head

Havit prints this range's outputs as 2 × a figure, and that is how they are stated below — one number describing one emitter, not the pair added together:

• HV1325T — two 9-in-1 switchable GU10 globes on 240 V. Each globe runs at 3 W, 5 W or 7 W, giving 2 × 240–560 lm at 3000K, 2 × 255–595 lm at 4000K and 2 × 270–630 lm at 5500K. Beam 60°, and this part number is Triac dimmable.
• HV1327GU10T — two fixed 5 W tri-colour GU10 globes, 2 × 270 / 285 / 300 lm, 120°.
• HV1327MR16T — the 12 V DC version on two MR16 globes, same per-head output and beam.

The 12 V version needs sizing, not just connecting

HV1327MR16T carries two lamps, so the driver has to be specified for both, not for one fitting. Havit's limits are firm: the light must sit within 25 m of its driver with the supply held within ±5% of 12 V, and outside that the warranty does not apply. It must never be connected to 240 V.

Where it can go

The rating is IP65, so a fully exposed wall needs no eave. The body is powder-coated aluminium, and Havit excludes aluminium and 304 stainless fittings from installation within 5 km of salt water. Inside that zone, ask us for the 316 stainless or solid brass double adjustable instead. Globes can be swapped later within the caps of 35 W on 240 V GU10 and 20 W on 12 V MR16, per lamp.

Wiring is parallel, CRI is above 80, and the warranty is 3 years replacement.

Earthing and protection class

This listing sells more than one supply, and the earthing requirement is not the same on both. Check which part number you are wiring before you start.

• HV1325T, HV1327GU10T run on 240 V AC mains and are Protection Class 1 — an earth is required at the fitting. Havit's installation sheet has the installer connect the earth conductor first, then live and neutral.
• HV1327MR16T run on 12 V DC and are Protection Class 3 — no earth is required at the fitting. The isolation comes from the LED driver rather than from an earth conductor, and these part numbers must never be connected directly to 240 V.