Bar Lights
Batten Lights
Batten Fix Lights(DIY)
Bedside Table Lamps
Cabinet Lights
Ceiling Lights
Chandeliers
Close to Ceiling Light (CTC)
Copper Lights
Emergency Lighting
Fairy Lights
Floor Lamps
High Bay Lights (UFO)
Lamps
Mirror Lights
Oyster Lights
Pendants Lighting
Plaster Wall Lights
Smart Lights
Spot Lights
Table Lamps
Touch Table Lamps
Up/Down Wall Lights
Vanity Lights
Wall Lights
LED Strips
LED Strips Controller
Batten Lights
Bollard Lighting
Brick Lights
Bunker Lights
Coach Lighting
Deck Lights
Driveway Lights
Fairy Lights
Flood Lights
Garden Lighting
Inground Lights
Pathway Lighting
Pillar Mount
Pond Lights
Posts Lights/Top
Outdoor Ceiling Lights
Outdoor Sensor Lights
Outdoor Wall Lights
Solar Lights
Spike Lights
Step Lights
Up/Down Wall Lights
Clearance Sale
LoginCouldn't load pickup availability
The HV5529T is the Gleam deep recessed downlight built for a Ø76 mm cut-out. That single number is the whole reason it exists alongside the Ø90 mm HV5528T: the light engine, the 9 W rating, the output, the beam and the ratings are identical, and only the hole in the ceiling is smaller. This listing carries seven insert combinations — HV5529T-BB, -BC, -BG, -WB, -WC, -WG and -WW — each a complete luminaire with its own driver, flex and plug.
A downlight is chosen twice: once for how it looks and once for whether it fits the hole. If you are replacing older fittings, matching the existing cut-out saves patching every ceiling in the room, and 76 mm is the size that the larger Gleam cannot cover. The body measures Ø82 mm across the face and 66 mm deep, rising to about 76 mm deep with the HV5528-IC4CAP fitted. One of Havit's own documents contradicts itself here: the installation sheet's specification table prints a 90 mm cut-out while its own dimension drawings on the same page print Ø76 twice. The dated model data sheet, the drawings and Havit's own product pages all say Ø76 mm, and that is the figure to cut to.
The insert is the visible bezel — black, chrome, gold or white, over a black or white face. It is a finish decision, not an optical one. All seven part numbers give 680 lm at 3000K, 795 lm at 4000K and 745 lm at 5500K from the same built-in 9 W LED, with a 90° beam and CRI >80. The colour temperature is set by a switch on the back before the fitting goes in, and the middle setting is the brightest — 5500K gives about 6% less than 4000K.
The fitting is IC-4 only when the HV5528-IC4CAP is used, that rating applies to the fitting only and the driver may not be installed under insulation, and the fixture must not be used with loose-fill insulation such as macerated paper or wool. The driver must sit above any insulation covering the fitting so it can ventilate.
It runs on 240 V AC from a separate driver, is Protection Class 2 so needs no earth at the fitting, is IK08, rated >30,000 hrs and Triac dimmable. IP54 covers the front of the fitting only. Havit's warranty line for these part numbers reads "3 Years replacement warranty (items ordered after 01/01/22)". Lights For You lists the Ø90 mm version of the same engine as HV5528T, and a dim-to-warm model on this identical Ø76 mm cut-out as HV5529D2W.
Ø76 mm. Its own dated data sheet states it twice, its dimension drawings state it twice more, and Havit’s page for each of these part numbers states it. Note that the installation sheet’s specification table prints 90 mm — that cell contradicts the drawings on the same document and is wrong for this model.
Only the hole. Same 9 W engine, same 680/795/745 lm, same 90° beam, same ratings — the HV5528T needs a Ø90 mm cut-out and the HV5529T needs Ø76 mm.
Yes. Each part number is a whole downlight with driver, flex and plug. Havit lists all nine HV5529T insert combinations in one Model No. row on the installation sheet, so the insert is a model variant rather than a separate accessory.
4000K, at 795 lm. 3000K gives 680 lm and 5500K gives 745 lm, so cooler is not brighter on this fitting.
The body is 66 mm deep and about 76 mm with the HV5528-IC4CAP fitted, plus room for the driver, which must sit above any insulation rather than under it.
Only with the HV5528-IC4CAP fitted, and only the fitting itself. Havit states the driver may not be installed under insulation, and that loose-fill insulation such as macerated paper or wool must not be used with this fixture at all.
Yes — Triac dimmable, with the HV9625 Triac dimmer offered to suit Havit’s Triac dimmable drivers. If you want the light to warm as it dims, that is the separate HV5529D2W model on the same cut-out.
| Range | Gleam |
|---|---|
| Type | Fixed deep recessed downlight — coloured insert |
| Finishes on this listing | Black or white body with black, chrome, gold or white insert |
| Material | Polycarbonate face with aluminium body |
| Diffuser | Plastic |
| Installation type | Ceiling — recessed |
| Cut-out | Ø76 mm |
| Dimensions | Ø82 mm × 66 mm deep (about 76 mm deep with HV5528-IC4CAP fitted) |
| Lamp base | Built-in LED |
| Power | 9 W |
| Colour temperature | Tri colour — 3000K, 4000K, 5500K (switch on the fitting) |
| Lumen output | 680 lm / 795 lm / 745 lm (3000K / 4000K / 5500K) — brightest at 4000K |
| Beam angle | 90° |
| CRI | >80 |
| IP rating | IP54 — front of the fitting only |
| IK rating | IK08 |
| IC rating | IC-4 only when used with HV5528-IC4CAP — fitting only; the driver may not be installed under insulation |
| Insulation | No loose-fill insulation; driver mounted above any insulation covering the fitting |
| Tilt | No |
| Input voltage | 240 V AC — separate driver, supplied with flex and plug |
| Protection class | Class 2 (no earth required) |
| Dimmable | Yes — Triac |
| Lamp expectancy | >30,000 hrs |
| Warranty | 3 Years Replacement* |
| Part number | Body / insert | Colour temperature | Lumens | Power | Beam angle | Cut-out | Supply | Barcode |
|---|---|---|---|---|---|---|---|---|
| HV5529T-BB | Black with black insert | 3000K / 4000K / 5500K | 680lm / 795lm / 745lm | 9 W | 90° | Ø76 mm | 240 V AC — flex and plug supplied | 9350418032287 |
| HV5529T-BC | Black with chrome insert | 3000K / 4000K / 5500K | 680lm / 795lm / 745lm | 9 W | 90° | Ø76 mm | 240 V AC — flex and plug supplied | 9350418032294 |
| HV5529T-BG | Black with gold insert | 3000K / 4000K / 5500K | 680lm / 795lm / 745lm | 9 W | 90° | Ø76 mm | 240 V AC — flex and plug supplied | 9350418032300 |
| HV5529T-WB | White with black insert | 3000K / 4000K / 5500K | 680lm / 795lm / 745lm | 9 W | 90° | Ø76 mm | 240 V AC — flex and plug supplied | 9350418032317 |
| HV5529T-WC | White with chrome insert | 3000K / 4000K / 5500K | 680lm / 795lm / 745lm | 9 W | 90° | Ø76 mm | 240 V AC — flex and plug supplied | 9350418032324 |
| HV5529T-WG | White with gold insert | 3000K / 4000K / 5500K | 680lm / 795lm / 745lm | 9 W | 90° | Ø76 mm | 240 V AC — flex and plug supplied | 9350418032331 |
| HV5529T-WW | White with white insert | 3000K / 4000K / 5500K | 680lm / 795lm / 745lm | 9 W | 90° | Ø76 mm | 240 V AC — flex and plug supplied | 9350418032348 |
For all warranty claims please ensure you have your proof of purchase at hand, an invoice from your electrician from the installation and check the faulty product is within the applicable warranty period. Warranty is replacement only.
Lights For You is not responsible for damages caused by unprofessional installation, modified products or manipulated by the customer or by any other person not authorised by the manufacturer; as well as by improper use, manipulation and/or short circuits, apparent signs of improper treatment.
Notification of any damages or missing items must be received by Lights For You within seven (7) days of receipt of the product. Please email photos to ashfield@lightsforyou.com.au.
If the product is to be repaired or replaced, it must correspond to the one originally sent by Lights For You and the customer must include the delivery note and/or invoice.
You must lodge a return request via the below request form.
Credits will be issued in the form of store credit or gift voucher and will be equal to the price paid for the product minus the cost of shipping. Store credit vouchers are valid for six months from the date of issuance.
We reserve the right to refuse a return in cases where we cannot be reasonably satisfied that you purchased the product from us or where we are not responsible for the damage in accordance with our Faults & damages policy.
Customers who wish to cancel all or part of an order due to change of mind or incorrectly ordered may do subject to cancelling in within 12 hours, during business hours from time of purchase. Once products have been shipped, you cannot cancel them.
Please refer to the following link to learn more about our policies
Learn MoreThanks for subscribing!
This email has been registered!
| Product | SKU | Product type | Other details |
|---|