EOS II EXTERIOR 1 WALL LIGHT

The EOS2 EX1 is a 90 mm single exterior wall light in polycarbonate — one GU10 lamp, IP54 — in black or white.

Built for salt air

The EOS2 is polycarbonate rather than metal, and that is the specification that matters within a few kilometres of the sea. Nothing corrodes — no rust bleeding down the render, no fixings weeping after two summers, no bubbling paint. Painted aluminium is fine inland; on a coastal wall, plastic wins.

Very small — and that is the use case

70 mm wide, 90 mm high, 0.2 kg. This is the smallest exterior fitting in the range. It disappears on a wall, which makes it right for a run of several down a fence line, a path or a facade where you want the light and not the fittings. The up-and-down EOS2 is the same width and 160 mm tall, so the two mix along one wall and still read as a family.

The lamp is not included — which works in your favour

One GU10 to 6 W, supplied separately. That means you choose the colour temperature and the beam angle — narrow for a tight architectural column, wide for a softer wash — and you can change your mind later. A sealed-LED fitting gives you no such choice and fails as a whole unit.

Double insulated

Class II — no earth required, which is unusual outdoors and means fewer connections to make and fewer to corrode.

Where it works

• Coastal properties — the reason it exists.
• Fence lines and facades, in a run.
• Covered entries and porches.
• Mixed with the up-and-down EOS2 along one wall.

Specifying it

70 mm wide, 90 mm high, 0.2 kg, in polycarbonate, sand finish. One GU10 lamp to 6 W, not supplied; dimming is globe dependent, CRI >80. 240 V, Class II — double insulated, no earth required, IP54 — covered outdoor positions. Warranty is three years, as a replacement warranty.

Supplied and supported by Lights For You.

Download Datasheet (PDF)