Domus
Domus
Loading... + Add to wishlist - Remove from wishlist
Domus Lighting
SKU: 24151

Domus PLEX-Rgb+tune/Wht 21W P/M COB Strip 24V IP54 840LED/M 1m

IP54 – dust and splashproof
IP54 – dust and splashproof
$60.95
$60.95
Product Description  
Product Description
x

The Domus PLEX-RGBTW is a 24 V COB LED strip — 21 W per metre, 840 LEDs per metre, IP54, 1 m, combining RGB colour with tuneable white.

⛔⛔ The datasheet attached to this listing is not for this product
  • ⭐ We compared the attached sheet against the verified sheet for the IP67 version of the same strip. ⭐ Seven specifications disagree, and not marginally:
Specification ⛔ The attached sheet ⭐ This product
LED type ⛔ 5050 SMD ⭐ COB
LEDs per metre ⛔ 60 ⭐ 840
Wattage per metre ⛔ 19.2 W ⭐ 21 W
IP rating ⛔ IP20 ⭐ IP54
CRI ⛔ 80 ⭐ ≥90
Beam angle ⛔ 120° ⭐ 180°
Cutting increment ⛔ 100 mm ⭐ 35.7 mm
  • ⭐ 60 LEDs per metre against 840 is a factor of fourteen. ⭐ IP20 against IP54 is the difference between a strip that must stay dry and one rated for wet areas. ⭐ These are two different products.
  • ⭐ SO WE HAVE NOT USED IT. ⭐ Every figure on this page comes from the verified sheet for the IP67 version of the same strip, with the IP rating taken from this product's own title and record.
  • ⚠ One consequence: we cannot give you per-channel lumens for the IP54 version specifically. ⭐ The IP67 figures are Red 110, Green 260, Blue 55 and white 285–325 lm per metre, ⭐ and elsewhere in this range the IP54 version runs about 15% BRIGHTER than IP67 because there is no silicon coating absorbing light. ⚠ We would expect the same here, but we have not measured it and we are not going to state it as published.
⭐ What we can say with confidence

⭐ The title, the product record and the family description agree on the important things: ⭐ 840 LEDs per metre, so genuinely dotless; 21 W per metre, the highest load in the strip range; 24 V DC; IP54, meaning indoor including wet areas; and RGB plus a separate tuneable white channel. ⭐ The run limit is 5 m from one end and 10 m from two.

⭐ The separate white channel is the point of the product

⭐ A plain RGB strip makes white by mixing three channels, and that white has spikes and gaps — skin and timber look wrong under it. ⭐ This carries a dedicated white channel that is tuneable in temperature and renders at CRI ≥90 on the verified sibling. ⭐ So one installation gives you proper everyday white and saturated colour when it is wanted, rather than a compromise at both.

⚠ And plan for blue being quiet

⭐ On the verified sibling, green measures 260 lm per metre and blue 55 — ⭐ a factor of 4.7. ⭐ That is the eye's own sensitivity curve rather than a fault, and it applies to every RGB product. ⚠ A blue-dominant scheme will read far quieter than the green or white ones. ⭐ Worth knowing before the strip is installed rather than after.

✅ What is published
Specification Value
⛔ Attached datasheet ⛔ Is for a DIFFERENT product — 7 specs disagree
⭐ Source used here ⭐ The verified sheet for the IP67 sibling
⭐ LED density ⭐ 840 per metre — ⭐ dotless
Load ⭐ 21 W per metre — ⭐ the highest in the range
IP rating IP54 — ⭐ indoor including wet areas
⭐ Continuous run 5 m one-end · ⭐ 10 m two-end
⭐ White channel ⭐ Separate, tuneable, ⭐ CRI ≥90 on the sibling
⚠ Per-channel lumens ⚠ Not available for IP54 — ⭐ ask us
⛔ Controller ⛔ REQUIRED as well as a driver
⛔ Aluminium heat sink ⛔ MANDATORY — VOIDS THE WARRANTY
⛔ Made to order, cut to length

No lead time is published. Call our team to confirm. ⭐ We will.

Where it works
  • ⭐ Indoor spaces wanting white daily and colour occasionally.
  • ⭐ Kitchens, bars, pelmets, living spaces.
  • ⭐ Where a dotless line matters — ⭐ 840 LEDs/m.
  • ⚠ Not outdoors — ⭐ IP54 is indoor wet areas; ⭐ take the IP67.
  • ⛔ Not without a controller.
Specifying it

RGBTW COB LED strip, IP54, 1 m. 21 W per metre at 24 V DC. 840 LEDs per metre, dotless. Separate tuneable white channel. 180° beam. Continuous run 5 m one-end, 10 m two-end. Driver AND controller required. Aluminium heat sink mandatory. 3-year warranty. ⛔⛔ THE DATASHEET ATTACHED TO THIS LISTING IS FOR A DIFFERENT PRODUCT — seven specifications disagree, including 60 LEDs per metre against 840 (a factor of fourteen) and IP20 against IP54. WE HAVE NOT USED IT. Every figure here comes from the verified sheet for the IP67 version of the same strip, and the IP rating from this product's own title and record. ⚠ One consequence: per-channel lumens for the IP54 version specifically are not available — ask us and we will get them from Domus.

Supplied and supported by Lights For You.

Questions
Is the datasheet on this listing correct?

No. We compared it against the verified sheet for the IP67 version of the same strip and seven specifications disagree — 5050 SMD against COB, 60 LEDs per metre against 840, 19.2W against 21W, IP20 against IP54, CRI80 against ≥90, 120 degrees against 180, and a 100mm cutting increment against 35.7mm. These are two different products.

So where do your figures come from?

The verified sheet for the IP67 version of the same strip, with the IP rating taken from this product's own title and record. We have not used the attached sheet for anything.

What can you not tell me?

Per-channel lumens for the IP54 version specifically. The IP67 figures are Red 110, Green 260, Blue 55 and white 285 to 325 lumens per metre, and elsewhere in this range the IP54 version runs about 15% brighter than IP67 because there is no silicon coating absorbing light. We would expect the same here — but we have not measured it and we will not state it as published. Ask us and we will get it from Domus.

What are you confident about?

840 LEDs per metre so genuinely dotless, 21W per metre which is the highest load in the strip range, 24V DC, IP54 meaning indoor including wet areas, and RGB plus a separate tuneable white channel. The run limit is 5 metres from one end and 10 from two. The title, the product record and the family description all agree on these.

Why does the separate white channel matter?

Because a plain RGB strip makes white by mixing three channels, and that white has spikes and gaps — skin and timber look wrong under it. This carries a dedicated white channel, tuneable in temperature and rendering at CRI ≥90 on the verified sibling. One installation gives proper everyday white and saturated colour when wanted, rather than a compromise at both.

Anything to plan for with colour?

Blue will be quiet. On the verified sibling green measures 260 lumens per metre and blue 55, a factor of 4.7 — the eye's own sensitivity curve rather than a fault, and it applies to every RGB product. A blue-dominant scheme reads far quieter than the green or white ones. Worth knowing before the strip is installed rather than after.

What else do I need?

A 24V DC constant-voltage driver and a controller to address the four channels, plus an aluminium profile — the heat-sink requirement voids the warranty if omitted. None of the three is included and none is mentioned on the page.

Product Specifications  
Product Specifications
x

Specifications

BrandDomus Lighting
Model / SKUPLEX-RGBTW IP54 1m — 24151
⛔⛔ THE ATTACHED DATASHEET IS FOR A DIFFERENT PRODUCT⭐ Seven specifications disagree
⛔ LEDs per metre⛔ Sheet says 60 · ⭐ product is 840 — ⭐ a factor of FOURTEEN
⛔ IP rating⛔ Sheet says IP20 · ⭐ product is IP54
⛔ Also disagreeingLED type · wattage · CRI · beam angle · cutting increment
⭐ SO WE HAVE NOT USED IT⭐ Figures here come from the VERIFIED IP67 sibling sheet
⚠ One consequence⚠ No per-channel lumens for IP54 specifically — ⭐ ask us
⭐ What we are confident about⭐ 840 LEDs/m dotless · ⭐ 21 W/m · IP54 · ⭐ separate white channel
⭐ Continuous run5 m one-end · ⭐ 10 m two-end
⚠ Plan for blue being quiet⭐ Green 260 lm/m vs blue 55 on the sibling — ⭐ a factor of 4.7
⛔ Driver AND controller AND profile⛔ None included, ⚠ none mentioned on the page

Variant specifications

Spec⛔ Attached sheet⭐ This product
LEDs/m⛔ 60⭐ 840
IP⛔ IP20⭐ IP54
LED type⛔ 5050 SMD⭐ COB
CRI⛔ 80⭐ ≥90
Data Sheet & Manual  
Data Sheet & Manual
x

This browser does not support PDFs. Please download the PDF to view it: Download PDF.

Download Datasheet (PDF)

Warranties, Return & Refund Policy  
Warranties, Return & Refund Policy
x

Warranties

For all warranty claims please ensure you have your proof of purchase at hand, an invoice from your electrician from the installation and check the faulty product is within the applicable warranty period. Warranty is replacement only.

Lights For You is not responsible for damages caused by unprofessional installation, modified products or manipulated by the customer or by any other person not authorised by the manufacturer; as well as by improper use, manipulation and/or short circuits, apparent signs of improper treatment.

Faulty items: lodge warranty directly with the brand (manufacturer). Keep proof of purchase.

Damaged or Missing Items

Notification of any damages or missing items must be received by Lights For You within seven (7) days of receipt of the product. Please email photos to ashfield@lightsforyou.com.au.

If the product is to be repaired or replaced, it must correspond to the one originally sent by Lights For You and the customer must include the delivery note and/or invoice.

Returns

Change of Mind Returns

  • Customers who wish to return a product due to a change of mind or cancelled order may do so within thirty (30) days of receipt.
  • The customer is responsible for the shipping costs for a change of mind return, irrespective of any free, discounted or any other type of shipping promotion that may have been applicable at the time of your order. This includes any costs you incur for us shipping the product to you in the first place and the cost of shipping the product back to us.

Lodge a Return

You must lodge a return request via the below request form.

Excluded from Change of Mind

  • Clearance items
  • Discontinued items
  • Globes
  • Custom items
  • Made to Order (incl. custom cut profiles & LED strips)
  • Lamp shades
  • T4 fluorescent tubes
  • Gift cards

Credits will be issued in the form of store credit or gift voucher and will be equal to the price paid for the product minus the cost of shipping. Store credit vouchers are valid for six months from the date of issuance.

Our Rights

We reserve the right to refuse a return in cases where we cannot be reasonably satisfied that you purchased the product from us or where we are not responsible for the damage in accordance with our Faults & damages policy.

Cancellations

Customers who wish to cancel all or part of an order due to change of mind or incorrectly ordered may do subject to cancelling in within 12 hours, during business hours from time of purchase. Once products have been shipped, you cannot cancel them.

Your Options

  • Restocking fee: 20% will apply unless otherwise stated, or unless another order of equal or greater value is placed in lieu of this re-stocking fee.
  • Credit: will be issued in the form of store credit and will be equal to the price paid.

    Please refer to the following link to learn more about our policies

    Learn More

Recently Viewed

Customers Also Bought

Vendor
Example product title
$60.95
$60.95
Vendor
Example product title
$60.95
$60.95
Vendor
Example product title
$60.95
$60.95
Vendor
Example product title
$60.95
$60.95
Vendor
Example product title
$60.95
$60.95
Vendor
Example product title
$60.95
$60.95
Vendor
Example product title
$60.95
$60.95
Vendor
Example product title
$60.95
$60.95
Vendor
Example product title
$60.95
$60.95
Vendor
Example product title
$60.95
$60.95