Domus Lighting LED Linear Pendants Domus Maxi 50 1.2m Long Pendant White Dimmable 4k
Domus Maxi 50 1.2m Long Pendant White Dimmable 4k
Domus Maxi 50 1.2m Long Pendant White Dimmable 4k
Domus Maxi 50 1.2m Long Pendant White Dimmable 4k
Domus Maxi 50 1.2m Long Pendant White Dimmable 4k
Domus Maxi 50 1.2m Long Pendant White Dimmable 4k
Domus Lighting LED Linear Pendants Domus Maxi 50 1.2m Long Pendant White Dimmable 4k
Domus Maxi 50 1.2m Long Pendant White Dimmable 4k
Domus Maxi 50 1.2m Long Pendant White Dimmable 4k
Domus Maxi 50 1.2m Long Pendant White Dimmable 4k
Domus Maxi 50 1.2m Long Pendant White Dimmable 4k
Domus Maxi 50 1.2m Long Pendant White Dimmable 4k
Loading... + Add to wishlist - Remove from wishlist
Domus Lighting
SKU: 30531

Domus Maxi 50 1.2m Long Pendant White Dimmable 4k

Beam angle for focused or wide lighting
120° Beam angle for focused or wide lighting
Dimmable
Dimmable
$406.00
$406.00
Product Description  
Product Description
x

The Domus Maxi 50 is a 1.2 m suspended LED linear pendant — 24 W, 2400 lm, 4000 K at CRI90, dimmable, in a white body, in six finishes.

⛔ Two of its six finishes share one product code — and they are the two hardest to tell apart
Finish SKU
Prismatic 30531
Frosted ⛔ 30532
Honeycomb 30533
Opal ⛔ 30532 — the same code
Black 30535 — ⚠ 30534 is absent
Clear 30536
  • ⚠ Frosted and opal are the two hardest finishes to distinguish — both give a white diffused face — ⭐ and they are also the two most likely to be ordered.
  • ⚠ So unlike the other Maxi 50 duplicate, where opal is paired with black and the difference is obvious, this error can survive delivery.
  • ⭐ Tell us the finish in words and we will confirm the code with Domus before the order goes in. ⭐ 2 of the 18 listings carry this fault, and both are at 1.2 m.
⭐ How to tell which one arrived — a check that actually works
  • ⚠ Do not look for individual LEDs. ⭐ The engine is a PLEX-COB-20W strip — chip-on-board, a continuous phosphor layer — ⭐ so the lit line is unbroken behind either diffuser and there are no dots to spot.
  • ⭐ Compare them instead, and look for two things:
Look at Opal Frosted
The unlit face ⭐ A denser, more solid white Lighter, slightly translucent
Brightness, lit ⚠ Marginally lower ⭐ Marginally higher
  • ⭐ The unlit face is the more reliable tell — ⭐ a denser diffuser looks denser switched off, ⚠ where a brightness difference of a few per cent is hard to judge by eye without the two side by side.
  • ⭐ Check it before it goes up. ⚠ Once a run is installed and wired, a finish swap is a made-to-order return on an unknown clock.
✅ The published specification
Specification Value
Light output ⭐ 2400 lm — 100 lm/W
Colour rendering ⭐ CRI90 at 4000 K
Light engine ⭐ PLEX-COB-20W — a continuous emitter
Power / length 24 W at 240 V · 1200 mm
Beam 120° recorded — ⚠ a range default across all six finishes
IP rating IP20 — ⚠ dry interior only
Suspension 3 m drop supplied
Warranty ⭐ 3 years, replacement
⛔ Per-finish output · lifespan ⛔ Not published
⛔ Made to order, and no lead time is published

Which sharpens the point above — ⭐ a replacement for a wrong finish is a made-to-order item. ⭐ Confirm the code first.

Where it works
  • Single desks, studies and home offices.
  • Reception desks and consulting rooms.
  • White and plasterboard ceilings.
  • ⭐ Over screens — ⭐ with the honeycomb.
  • ⛔ Not ordered on the dropdown alone — ⚠ two finishes share a code.
Specifying it

1.2 m suspended LED linear pendant. 2400 lm, 24 W (100 lm/W), 4000 K, CRI90. IP20. 1200 mm. 3 m drop. PLEX-COB-20W strip, integral dimmable driver, DALI and emergency on request. White powder-coated aluminium body. Six finishes. 3-year replacement warranty. Order code MAXI-50-1.2M-W-4K. ⛔ "FROSTED" AND "OPAL" BOTH RESOLVE TO 30532, and 30534 is absent — ⚠ the two hardest finishes to tell apart and the two most likely to be ordered. ⭐ TO CHECK WHICH ARRIVED, look at the UNLIT face: opal is a denser, more solid white. ⚠ Do not look for individual LEDs — the engine is a COB strip and the lit line is unbroken behind either.

Supplied and supported by Lights For You.

Questions
Why do two finishes have the same code?

"Frosted" and "Opal" both resolve to SKU 30532, and 30534 — the code the sequence requires — is absent. Two of the 18 Maxi 50 listings carry this fault and both are at 1.2m. This is the awkward pairing: frosted and opal are the two hardest finishes to distinguish, since both give a white diffused face, and they are also the two most likely to be ordered.

How can I tell which one arrived?

Look at the unlit face — that is the more reliable tell. Opal is a denser, more solid white; frosted is lighter and slightly translucent. Lit, opal is marginally dimmer, but a difference of a few per cent is hard to judge by eye without the two side by side. What you should not do is look for individual LEDs, because there are none to find.

Why are there no individual LEDs to look for?

The engine is a PLEX-COB-20W strip — chip-on-board, meaning many small emitters under a single continuous phosphor layer rather than separately packaged LEDs spaced along a strip. So the lit line is unbroken behind either diffuser, and the usual trick of looking for dots or scalloping to identify a diffuser does not work here.

When should I check?

Before it goes up. Once a run is installed and wired, a finish swap is a made-to-order return on an unknown clock, since Domus publishes no lead time. Better still, tell us the finish in words when you order and we will confirm the code with Domus first.

What is the actual difference between them?

Diffusion density, which trades smoothness against output. Opal is denser: the most uniform face, and it passes less light. Frosted is lighter: more output, and a slightly less even face at a shallow angle. The rule is opal where the fitting is seen close and side-on, frosted where it is above head height and the output matters. Neither figure is published per finish.

Which finish over a screen?

The honeycomb — a cellular baffle that blocks light above a cut-off angle, so it removes the high-angle output that reflects in a monitor rather than softening it. Prismatic is the efficient alternative, redirecting that light downward rather than absorbing it, so you keep the output.

Can I use it in a damp space?

No — IP20, dry interior only. For bathrooms, covered outdoor areas, commercial kitchens or unsealed bays, ask us about the Domus IMPACT range at IP66 and IK10.

Product Specifications  
Product Specifications
x

Specifications

BrandDomus Lighting
Model / SKUsMaxi 50 1.2m White 4000K — 30531 Prismatic, ⛔ 30532 Frosted, 30533 Honeycomb, ⛔ 30532 Opal, 30535 Black, 30536 Clear
Order codeMAXI-50-1.2M-W-4K
⛔ Duplicate code"Frosted" and "Opal" BOTH resolve to 30532 — ⚠ 30534 absent
⚠ Why this is the awkward pairingThe two hardest to tell apart AND the two most likely to be ordered
⭐ HOW TO CHECK — the unlit face⭐ Opal is a DENSER, more solid white · frosted is lighter and translucent
⚠ Lit brightnessOpal marginally lower — ⚠ hard to judge without both side by side
⛔ Do NOT look for individual LEDs⭐ The engine is a COB strip — ⭐ the lit line is unbroken behind either
⭐ WHEN to checkBEFORE it goes up — ⚠ a swap afterwards is a made-to-order return
⭐ What actually differsDiffusion DENSITY — ⭐ smoothness against output
✅ Light output2400lm — ⭐ 100 lm/W
✅ CRI⭐ CRI90 at 4000K
⚠ IP ratingIP20 — dry interior only

Variant specifications

CheckOpalFrostedReliable?
⭐ Unlit face⭐ Denser, solid whiteLighter, translucent⭐ Yes
Lit brightness⚠ Marginally lowerMarginally higher⚠ Hard to judge
⛔ Individual LEDs⛔ None⛔ None⛔ No — COB strip
Warranties, Return & Refund Policy  
Warranties, Return & Refund Policy
x

Warranties

For all warranty claims please ensure you have your proof of purchase at hand, an invoice from your electrician from the installation and check the faulty product is within the applicable warranty period. Warranty is replacement only.

Lights For You is not responsible for damages caused by unprofessional installation, modified products or manipulated by the customer or by any other person not authorised by the manufacturer; as well as by improper use, manipulation and/or short circuits, apparent signs of improper treatment.

Faulty items: lodge warranty directly with the brand (manufacturer). Keep proof of purchase.

Damaged or Missing Items

Notification of any damages or missing items must be received by Lights For You within seven (7) days of receipt of the product. Please email photos to ashfield@lightsforyou.com.au.

If the product is to be repaired or replaced, it must correspond to the one originally sent by Lights For You and the customer must include the delivery note and/or invoice.

Returns

Change of Mind Returns

  • Customers who wish to return a product due to a change of mind or cancelled order may do so within thirty (30) days of receipt.
  • The customer is responsible for the shipping costs for a change of mind return, irrespective of any free, discounted or any other type of shipping promotion that may have been applicable at the time of your order. This includes any costs you incur for us shipping the product to you in the first place and the cost of shipping the product back to us.

Lodge a Return

You must lodge a return request via the below request form.

Excluded from Change of Mind

  • Clearance items
  • Discontinued items
  • Globes
  • Custom items
  • Made to Order (incl. custom cut profiles & LED strips)
  • Lamp shades
  • T4 fluorescent tubes
  • Gift cards

Credits will be issued in the form of store credit or gift voucher and will be equal to the price paid for the product minus the cost of shipping. Store credit vouchers are valid for six months from the date of issuance.

Our Rights

We reserve the right to refuse a return in cases where we cannot be reasonably satisfied that you purchased the product from us or where we are not responsible for the damage in accordance with our Faults & damages policy.

Cancellations

Customers who wish to cancel all or part of an order due to change of mind or incorrectly ordered may do subject to cancelling in within 12 hours, during business hours from time of purchase. Once products have been shipped, you cannot cancel them.

Your Options

  • Restocking fee: 20% will apply unless otherwise stated, or unless another order of equal or greater value is placed in lieu of this re-stocking fee.
  • Credit: will be issued in the form of store credit and will be equal to the price paid.

    Please refer to the following link to learn more about our policies

    Learn More

Recently Viewed

Customers Also Bought

Vendor
Example product title
From $406.00
From $406.00
Vendor
Example product title
From $406.00
From $406.00
Vendor
Example product title
From $406.00
From $406.00
Vendor
Example product title
From $406.00
From $406.00
Vendor
Example product title
From $406.00
From $406.00
Vendor
Example product title
From $406.00
From $406.00
Vendor
Example product title
From $406.00
From $406.00
Vendor
Example product title
From $406.00
From $406.00
Vendor
Example product title
From $406.00
From $406.00
Vendor
Example product title
From $406.00
From $406.00