Arvin 60 LED Vanity Light

The Arvin 60 is a 620 mm LED vanity light with the LED built in — a very slim bar, only 25 mm high, for above a bathroom mirror. That slimness is the difference between it and the chunkier Foley: the Arvin reads as a line of light rather than a fitting.

IP44, and where that lets it go

Rated IP44, it is protected against splashing from any direction — the requirement for a fitting above a basin. Australian wiring rules set zones around baths and showers, and your electrician will confirm the fitting suits the position; above a vanity mirror is the normal one, not inside a shower enclosure.

Choose the colour temperature before it goes up

It is 3 CCT — 3000 K, 4000 K or 5000 K, selected at installation. Over a mirror, 4000 K is usually right: it renders skin honestly for shaving and make-up without the clinical edge of 5000 K. With CRI above 83 colours read accurately, which is the specification that actually matters in a bathroom.

Match it to the mirror

At 620 mm this suits a mirror of roughly 700 mm or wider, centred above it. The Arvin comes in other lengths as separate listings, so check the family if your mirror is a different size rather than forcing this one.

Where it works

• Above a vanity mirror in a bathroom, ensuite or powder room.
• Narrower vanities where the 800 mm Foley would overhang.
• Laundries and utility rooms needing a splash-rated linear fitting.
• Mirrored dressing areas, mounted above the glass.

Specifying it

It is 620 mm wide, 25 mm high, projecting 100 mm, weighing 1.24 kg, in aluminium and polycarbonate. The 12 W LED is built in and supplied, giving 892 lm — no globe to buy or replace. It is not dimmable, runs on 240 V, and is Class I — an earth is required. Finishes are antique gold, black or chrome. Warranty is three years.

Supplied and supported by Lights For You. Because it is non-dimmable, give it its own switch rather than a shared dimmed circuit.

Download Datasheet (PDF)

Download Datasheet (PDF)