Liptor Surface Mounted LED Bunker

This is the larger Liptor: the same flat aluminium disc as the 10 W model, taken out to 275 mm across and 20 W. It is the size that works as the only light in a bedroom, a small living room, a study or a decent bathroom, where the smaller one would leave the corners short.

Output, and where it peaks

Tri-colour again, and again the peak is in the middle: 1,130 lm at 3000K, 1,360 lm at 4000K and 1,310 lm at 5500K. Between the warmest and the middle setting there is a real difference of about 230 lm — roughly a fifth more light — so if a room feels marginal on 3000K, moving it to 4000K gains more than the colour change alone would suggest. All three settings render at CRI >80 and the setting is chosen at installation rather than bought as a separate code.

Sizing it against the small one

At 20 W it produces close to three times the light of the 10 W Liptor for twice the power, because the larger body runs a bigger emitter at a more efficient point rather than simply doubling the same one. It is also 81 mm wider, which matters visually: at 275 mm this reads as the room’s light fitting, where the 194 mm version reads as a utility fitting. If both are going into one house, that difference is worth deciding deliberately rather than by wattage alone.

Build and rating

Powder-coated aluminium body in black or white, opal polycarbonate lens, IP54 and IK06. IP54 covers dust and splashing water from any direction, which suits a bathroom ceiling away from the shower, a covered outdoor area or an eave, but not direct spray. Being a metal-bodied fitting it is Protection Class 1 and needs an earth at the light — worth saying to the electrician, because plastic-bodied oysters of a similar look are Class 2 and do not.

Installation

Surface mounted with no cutout: a 93 × 93 mm base plate fixes to the ceiling and the fitting mounts onto it. It runs on 240 V AC without a driver, wired in parallel across a run, with a 120° beam. It is not dimmable and should not be put on a dimmer circuit.

Warranty is 3 years replacement. Lights For You holds both finishes and both Liptor sizes in stock, which is what makes it practical to specify one fitting family across a whole house.

Coastal siting — Havit’s condition

Havit’s installation instructions for this fitting state that aluminium and 304 stainless steel fittings must not be installed within 5 km of any salt water environment. That is a condition on where the fitting may go, and it sits beside the IP rating rather than inside it: a fitting can be rated for direct rain and still fall outside this rule, because the issue is salt carried in the air rather than water landing on the surface. If your site is inside that zone, talk to us before you specify it — Lights For You can point you at a fitting whose material Havit does not name here.

Download Datasheet (PDF)

Download Datasheet (PDF)