Nella Brass Coloured Surface Mounted Round Downlight

This is the 7 W extension body in brass-coloured aluminium — Ø75 mm across and 200 mm deep, exactly twice the length of the standard body on the same Ø72 mm plate. Four brass listings on this site share one title, so use the part number: this one ends -BR-EXT and it is the long, slim one.

Why a longer body, when the light is identical

The extension adds nothing optically. Same 7 W engine, same 60° beam, same 499 / 512 / 558 / 593 / 601 lm. What it adds is presence and reach. A 100 mm brass cylinder on a 3 m ceiling reads as a small disc; a 200 mm one reads as a deliberate object, which is usually the point of choosing a brass finish in the first place. It also pushes the source below a deep cornice, bulkhead or coffer that would otherwise cut into the beam. Where neither matters, the shorter body is the cheaper answer.

Indoors only, and Havit says so on the sheet

The brass finish carries a restriction the black and white versions of this body do not. Havit footnotes its own colour row: "Brass Model can only be used indoors". The IP54 rating describes what the body resists; this footnote describes where Havit will stand behind it. Treat this as an interior fitting — hallways, stairwells, living rooms, retail — and not a covered-outdoor one.

Light quality

Five switchable colour temperatures from 2700K to 5700K, with output climbing across the range by about 20% in total, so the setting is a mood decision more than a brightness one. Behind the lens is a honeycomb baffle, and the glare rating Havit publishes is UGR <10 — low enough that the fitting can sit in eyeline down a corridor without becoming the brightest thing in it. CRI >90 and SDCM <3 mean the light renders warm materials properly and consecutive fittings match one another.

Supply, earthing and dimming

Both circuits are on this page. The 240 V model is Protection Class 1 — an earth is required, and Havit's step is to land it before positive and neutral — and it is the Triac dimmable version. The 12 V DC model needs a constant-voltage driver, wires in parallel, is Protection Class 3 with no earth at the fitting, and Havit rates it not dimmable. The bodies are identical; the circuits are not.

Fixing and warranty

No cut-out is needed — the Ø72 mm base plate screws to the ceiling through two 9 × 4 mm slots and the body twists onto it. The colour switch sits inside the body and ships preset to 3000K, so set it before the fitting goes up. It is IP54, IK08, rated >30,000 hrs, and Havit excludes aluminium fittings from sites within 5 km of salt water. Warranty is 3 years replacement. Lights For You also lists this extension body at 12 W, at 240 mm, for rooms that need the same look with more output.

Download Datasheet (PDF)

Download Datasheet (PDF)