DOMUS SANDS-TL TIMBER TABLE LAMP 1XE27

The Domus SANDS-TL is a timber table lamp — open-slat natural plywood, 320 × 320 × 540 mm, 1 × E27, 240 V, 25 W maximum.

⭐ An open-slat shade changes what the lamp does

• ⭐ A solid shade contains the light and throws it up and down. ⭐ An open-slat one lets light through the gaps, so the lamp casts a pattern onto the surfaces around it as well as lighting them.
• ⭐⭐ THAT MAKES THIS A LAMP WHOSE EFFECT DEPENDS ON WHERE YOU PUT IT. ⭐ Against a plain wall, the slat pattern becomes part of the room. In the middle of a table with nothing behind it, most of that effect is lost. ⭐ On a sideboard or a bedside table against a wall is where it does the most.
• ⭐ AND IT MAKES THE LAMP CHOICE STRUCTURAL RATHER THAN COSMETIC.
  • ⭐ A clear or filament lamp throws hard-edged shadows and a strong pattern — ⭐ dramatic, and glary if the lamp is visible through a gap at eye level.
  • ⭐ An opal or frosted lamp throws a soft pattern and no glare — ⭐ which for a bedside or a living room is usually the better answer.
• ⭐ The lamp is not included, so this is a decision you make rather than one made for you. ⭐ Tell us the position and we will suggest one.

⭐ 540 mm tall — check it against the surface

⭐ At 540 mm this is a substantial table lamp, and the height is the figure most worth checking. ⭐ ON A BEDSIDE TABLE the useful test is whether the bottom of the shade sits near the eye level of someone sitting up in bed — ⭐ too high and you look straight at the lamp; too low and it lights the table rather than the book. ⭐ A 540 mm lamp on a 600 mm bedside puts the shade at around 1,140 mm, which is about right for most beds. ⭐ ON A SIDEBOARD at 850 mm it will read as a floor-standing element rather than an accessory — ⭐ which can be exactly right in a hallway, and overbearing in a small room.

⭐ Natural plywood — one finish, and it behaves like timber

⭐ Natural plywood is the only finish, and it is genuine timber rather than a print. ⭐ That means it will warm in tone over time, particularly in sunlight — ⭐ and it means each lamp's grain is slightly different. ⭐ If you are buying a pair for matching bedsides, they will be similar rather than identical, which is usually read as a feature. ⚠ Away from direct sun the change is slow; on a windowsill it is noticeable within a year.

⭐ Part of a family, which matters for a scheme

⭐ The SANDS series includes a matching pendant. ⭐ Using the table lamp and the pendant in one space gives a coherent look that a single piece cannot — ⭐ the same slat language at two scales and two heights. ⭐ It works particularly well where a pendant over a dining table is echoed by a lamp on a nearby sideboard. ⭐ Ask us about the pendant if the scheme has room for both.

⭐ E27 at 25 W max — and why the maximum matters here

⭐ The holder accepts up to 25 W. ⚠ ON A TIMBER SHADE THAT CEILING IS NOT JUST ELECTRICAL. ⭐ Timber and heat are a poor combination over years, and an open-slat shade sits closer to the lamp than a fabric one would. ⭐ A modern LED at 8 to 10 W will give plenty of light for a table lamp and run cool — ⭐ there is no reason to go near the maximum, and good reason not to.

✅ What is published

Where it works

• ⭐ Sideboards and bedsides against a wall — ⭐ the pattern lands.
• ⭐ Hallways — ⭐ 540 mm reads as a considered element.
• ⭐ With the matching pendant — ⭐ one language, two scales.
• ⚠ Not mid-table with nothing behind — ⭐ the effect is lost.
• ⚠ Not with a clear lamp at eye level — ⭐ glare through the slats.

Specifying it

Open-slat natural plywood table lamp. 320 × 320 × 540 mm. 1 × E27, 25 W maximum, lamp not included. 220–240 V. IP20. Matching pendant available. 1-year warranty. ⭐ AN OPEN-SLAT SHADE MAKES THE LAMP CHOICE STRUCTURAL RATHER THAN COSMETIC. A clear or filament lamp throws a hard-edged pattern and glares through the gaps at eye level; an opal lamp throws a soft pattern and no glare, which for a bedside or living room is usually the better answer. ⭐ AND THE EFFECT DEPENDS ON POSITION: against a plain wall the slat pattern becomes part of the room; mid-table with nothing behind it, most of that is lost. ⚠ Stay well below the 25 W maximum — timber and heat are a poor combination over years, and 8 to 10 W of LED is plenty.

Supplied and supported by Lights For You.

Download Datasheet (PDF)