Aqua-10 - 10W Led Dimmable Deep Face Wet Area Downlight Ip65 240V

The Domus AQUA-10 is a 10 W IP65 wet-area downlight in black or white — CRI above 90, a 60° beam, switchable 3000 K / 4000 K / 5700 K, and a Ø75–80 mm cutout, in TRIO or DALI.

IP65 — what it lets you do

Dust tight and protected against water jets from any direction. That is a high rating for a downlight and it opens up placements most fittings cannot take:

• Bathrooms and ensuites, closer to the shower than an IP44 fitting.
• Above a bath.
• Laundries, and covered outdoor ceilings — alfresco, verandah, carport.

⚠ Your electrician still sites it to the zones in AS/NZS 3000; the rating is a capability, not a permission. Rated −20 °C to 45 °C, which covers an Australian eave.

✅ CRI above 90 — and why it matters more here than anywhere

Most downlights sit at CRI 80. Above 90 means colours read as they do in daylight. In a bathroom the thing you look at under this light is your own face — a low-CRI fitting over a mirror drains skin and makes it impossible to judge makeup. This is the specification that separates a good bathroom downlight from a cheap one, and it was on no page.

⚠ The top setting is 5700 K, not 5000 K

• 3000 K — warm; the choice if the bathroom opens off a bedroom.
• 4000 K — the right answer for most bathrooms, and with CRI 90+ behind it a genuinely good light to see by.
• ⚠ 5700 K — colder and bluer than the 5000 K you may be expecting. Good in a laundry or garage, harsh in a bathroom.

Set on a dip switch before installation, and it cannot be changed from a switch afterwards. Our own record carries no colour temperature for this product at all, so these three settings exist only in the datasheet — decide before your electrician starts.

TRIO or DALI

• TRIO — dims from a standard suitable dimmer. This is the one for a house.
• DALI — addressable digital control needing a DALI bus and a controller. For a commercial or managed system, not a domestic bathroom.

⚠ Tell us the dimmer you plan to use. LED dimming compatibility is far cheaper to settle before installation than after.

The numbers

• 870 lm at 3000 K, 980 lm at 4000 K, 930 lm at 5700 K.
• 98 lm/W — efficient for a sealed wet-area fitting.
• Power factor ≥0.9, which counts if you are running many on one circuit.
• Cutout Ø75–80 mm, face 90 mm, depth 49.4 mm, aluminium, 50,000 hrs.

At 980 lm plan roughly 1.5 m spacing from a 2.4 m ceiling for even bathroom coverage.

Where it works

• Bathrooms, ensuites and above a bath — IP65 with CRI 90+.
• Laundries, alfresco ceilings, verandahs and carports.
• Ceilings already cut for 75 mm downlights, and shallow voids.
• ⚠ Choose 4000 K unless you have a reason not to.
• ⚠ Buy TRIO unless you have a DALI system.

Specifying it

Cutout Ø75–80 mm, face 90 mm, depth 49.4 mm, aluminium. 10 W LED giving 870 / 980 / 930 lm at 3000 K / 4000 K / 5700 K, dip switch, set before installation; CRI >90, 60° beam, power factor ≥0.9, 50,000 hrs, −20 °C to 45 °C. TRIO (dimmable with a suitable dimmer) or DALI. 220–240 V AC, IP65 — dust tight, protected against water jets. Warranty 3 years.

Supplied and supported by Lights For You.

Download Datasheet (PDF)

Download Datasheet (PDF)